Pool Cages

Pool cage and pool enclosure installation in Polk County

A pool cage in Central Florida is not decoration. It keeps leaves and oak catkins out of the water, it cuts chemical use, it keeps wildlife out of a yard that backs onto a lake, and under Florida's pool safety law a properly built enclosure can serve as your required barrier. The frame is engineered for the wind speed at your address and anchored into the deck. We connect you with Polk County crews who build full cages, not handymen who do a little of everything.

(863) 777-5379 Request a quote

Aluminum pool cage with a mansard roof over a screened pool deck in Polk County

What's included in this service?

Measure the deck and confirm it can carry the anchor loads before quoting
Get the frame engineered and sealed for the design wind speed at your address
Build mansard, gable, or dome roof styles depending on span and headroom
Set a super gutter along the house side so roof runoff does not sheet into the pool
Install chair rail and kick plate at the base, plus a door on each access side
Use the hurricane-rated fasteners and anchor spacing the engineering calls for
Handle the permit, the inspection, and the barrier-compliant door hardware

When do you need this service?

A new pool that was built without a cage
An old cage that is past repair and needs a full replacement
Constant leaf and debris load driving up chemical and equipment costs
A yard backing onto a lake or conservation area with wildlife coming in
Needing a compliant pool barrier without fencing the whole yard

What do homeowners ask about Pool Cages?

How much does a pool cage cost in Polk County?

Most residential cages in the Lakeland area land between $9,000 and $18,000. A large deck, a two-story mansard tied into the house wall, or a high clear span pushes it to $20,000 to $35,000. Price tracks the aluminum, the engineering, and the height far more than the screen. The screen itself is one of the cheapest parts of the job, which is why rescreening later costs so much less than the original build.

Does a pool cage count as a pool barrier in Florida?

It can, and that is one reason people build them. Florida's Residential Swimming Pool Safety Act lets a screen enclosure serve as the required barrier when it meets the requirements, which mostly come down to door hardware: self-closing, self-latching, with the latch set high enough that a small child cannot reach it. Ask the contractor to confirm the hardware they are quoting meets the barrier requirement, because a standard lanai door does not.

What wind speed is my cage engineered for?

Whatever the Florida Building Code assigns to your specific address, which the permit package spells out. Inland Polk County carries a lower design wind speed than the coastal counties, which is real money saved on aluminum compared to building the same cage in Pinellas. It does not mean the engineering is optional. Any cage going up without a sealed drawing is going up without a permit.

Mansard, gable, or dome roof?

Mansard is the default and the most common in Polk County: sloped sides into a flat top, good headroom, and it sheds debris. Gable gives you the most height in the middle and looks better on a two-story house, but it costs more. Dome is the cheapest and the lowest. If you have tall doors or a diving board, headroom drives the decision more than looks do.

How long does a pool cage take start to finish?

Plan on six to twelve weeks total. The build is one to two weeks. The rest is engineering, permit review, and material lead time. After a hurricane those timelines stretch badly because every aluminum shop in Central Florida is booked, so the worst time to start is right after a storm.